Airport Terminal & Aviation Facility Roofing in Allentown, PA

Airport Terminal & Aviation Facility Roofing

Airport terminal and aviation facility roofing in Allentown, PA starts with an understanding that these structures can't follow a standard commercial timeline. Lehigh Valley International Airport (ABE) — serves the Lehigh Valley metro including Allentown, Bethlehem, and Easton — operates around the clock, and every work access point, material lift, and crew deployment must be coordinated with the airport's facilities department, the FAA Part 139 safety program, and in some cases TSA security protocols. We build that coordination into the project scope before the contract is signed, not after mobilization.

ABE's terminal upgrades and growing cargo facilities, combined with the Lehigh Valley's dense warehouse and logistics corridor, make airport-area roofing a recurring commercial need.

The roofing systems on airport terminals and aviation support structures carry requirements beyond standard commercial membranes. Jet blast exposure on airside roofs requires membrane adhesion and ballast specifications that exceed what you'd specify for a comparable logistics building. HVAC systems on terminals are denser and heavier than standard commercial, requiring a higher number of curbed penetrations and more frequent flashing maintenance touchpoints. Terminal roofs often span long, flat expanses with minimal slope — which means drainage design is critical and ponding tolerance is near zero. We've done this work, and we don't learn those lessons on your project.

Aviation-adjacent commercial roofing — cargo facilities, rental car centers, FBO hangars, aircraft maintenance facilities, hotel structures on airport campuses — presents a different set of challenges than the terminal building itself, but the airport coordination requirement doesn't go away. Our crews understand that badging and security access at any part of an airport campus is non-negotiable and is planned for, not discovered onsite.

For general aviation facilities — FBOs, private hangars, and reliever airport structures — the security protocols are less intensive but the building type is often more demanding. High-bay hangar structures with large clear-span roofs require specific fastening patterns and seam geometry to handle the wind uplift loads these buildings generate. We spec and install those systems in Allentown and throughout PA.

We work with the airport facilities department and FAA Part 139 coordinator to develop a phased work plan approved by airport operations. Material deliveries, crane lifts, and any work near airside areas are scheduled during approved windows and coordinated with the FAA NOTAM process if required. We've done this at multiple airports and it's a standard part of our project setup — not an exception.

Most terminal re-roofing in Allentown uses a TPO or PVC single-ply membrane on a tapered insulation system designed to improve drainage and address ponding. For new high-bay aviation structures and hangars, standing seam metal is often specified. The selection depends on the existing deck, load capacity, and operational constraints — we develop a spec after walking the roof with your facilities engineer.

Terminal HVAC density is significantly higher than standard commercial. Our pre-project survey documents every penetration, curb height, and mechanical clearance before we develop the work plan. Flashing details for oversized equipment curbs and complex through-penetrations are engineered individually — we don't use standard residential-pattern flashing details on aviation structures.

Related Roof Decisions